Posts: 481
Threads: 0
Joined: May 2003
Location: Rhode Island
Quick question. Having a problem moving the "handle". It just won't go down. On previous cuts, it was a little stiff, but I could lower and cut. Blade spins, and everything else seems okay. Anything in particular I should be looking at ? Torsion spring ? Manual wasn't much help.
I think (hope) I see a new saw in my future.
Posts: 3,493
Threads: 0
Joined: Jun 2008
Get a C10FSH and dont look back. But you might try some dry lube on the parts first.
Posts: 81
Threads: 0
Joined: Jul 2010
Flood it with WD40. You might have something jammed in the pivot. Try to loosen some of the parts to allow the WD40 to flow ionto all the nooks and crannies. If it loosens up wipe down really well because the WD40 will become a dust magnet. If it won't move after that it might be time for a new one.
Posts: 481
Threads: 0
Joined: May 2003
Location: Rhode Island
Thanks. Will give the WD40 a try, may try the dry lube first. Thanks for the recommendation, but I don't think I would buy another Hitachi.
Posts: 481
Threads: 0
Joined: May 2003
Location: Rhode Island
Well don't I feel stupid. Turns out the "cutter shaft guard" had come a little loose, and was slightly out of position. Tightened the screw, no more problem.
I've had the saw for almost 30 years, i still think its time for a new one.
Posts: 7,985
Threads: 0
Joined: Feb 2007
Jeremy s said:
Get a C10FSH and dont look back. But you might try some dry lube on the parts first.
I have one those in my garage.
