Posts: 14,809
Threads: 1
Joined: Dec 2006
Location: Traverse City MI
Just because it was the last time he used it.
I am making a batch of flag cases- cut one end of each piece, started to cut them to length and I noticed my gauge was off. Luckily I caught it before I ruined any pieces.
Posts: 5,119
Threads: 12
Joined: Apr 2009
Location: SoMar
A lot of squares are not square either.
Posts: 7,902
Threads: 0
Joined: Jan 2007
Are you going to recut the not quite 90 ends?
RD
------------------------------------------------------------------
"Boy could I have used those pocket screws!" ---Duncan Phyfe
Posts: 14,809
Threads: 1
Joined: Dec 2006
Location: Traverse City MI
Richard D. said:
Are you going to recut the not quite 90 ends?
Already done
Posts: 366
Threads: 0
Joined: Jun 2009
Herb G said:
A lot of squares are not square either.
Particularly traditional woodworking squares - the reason I use only good quality all steel engineering squares.
Posts: 20,381
Threads: 4
Joined: Sep 2007
Location: CinDay
A 90 is really easy to check, and I do that right before using it. As they say "stuff happens"
Worst thing they can do is cook ya and eat ya
GW
Posts: 850
Threads: 0
Joined: Dec 2006
Goaliedad
This happened to me from time to time. Sometimes I would not notice as quickly as you did and spoil some good lumber. My solution was to get my miter gauge as exactly square as possible (five-cut procedure) and then lock it in place. After that I used a "pattern making jig" (Ian Kirby) or a spare miter gauge to cut angles. Usually the former.
Doug
Posts: 2,274
Threads: 90
Joined: Jun 2001
I have a habit of checking my miter gauge and blades to be square each time I start a project. If I change a setting I make sure it's square again. It only takes a few seconds and really saves a lot of fixing things. I use plastic drafting triangles. Thy stay pretty much perfect.
John
Always use the right tool for the job.
We need to clean house.
Posts: 901
Threads: 0
Joined: Jul 2006
Location: Fripp Island, SC
John Mihich said:
I have a habit of checking my miter gauge and blades to be square each time I start a project. If I change a setting I make sure it's square again. It only takes a few seconds and really saves a lot of fixing things. I use plastic drafting triangles. Thy stay pretty much perfect.
+1, only I use a machinist square by Starrett.
Posts: 14,809
Threads: 1
Joined: Dec 2006
Location: Traverse City MI
Doug_H said:
Goaliedad
This happened to me from time to time. Sometimes I would not notice as quickly as you did and spoil some good lumber. My solution was to get my miter gauge as exactly square as possible (five-cut procedure) and then lock it in place. After that I used a "pattern making jig" (Ian Kirby) or a spare miter gauge to cut angles. Usually the former.
Doug
I have a Dubby sled- I love it- and easy to reset to 90. I looked down and saw a slight gap between the fence and the stop.
