Segmented Blanks and Hand Tools?

[Doug_H]

Hi

Do you have any thoughts on how to make segmented turning blanks with a miter box or band saw? Without too much drudgery, that is.

I was an enthusiastic turner of segmented bowls, vessels and lamps, until about a year ago when I downsized my shop. I gave up space for my table saw and chop saw. I kept a band saw, router table, and my lathe. Now I rip on the band saw and crosscut with a miter box.

I want to get back to segmented turning but the idea of cutting 100 plus segments per object with a miter box is a bit discouraging. Maybe the band saw will work. I have gotten pretty good with jigs for a circular (carpenter's ) saw, maybe I could cook up something to cut segments. I'm writing to see if you have any suggestions about how to do this.

To put this in perspective: a chop saw or portable table saw is the obvious solution but it would really crowd my shop. Or, I could drive 20 min each way to my son's shop where my old TS and all my segment jigs live now. So this is not a huge deal. I'm just wondering what ideas you may have.

Doug

[SteveS]

You could probably use a BS with a high tpi count but I would expect it would still require sanding every cut edge. It always seemed too tedious so I never attempted it, but some of the designs out there certain have that wow factor that make it a bit tempting.

Best just to go to penturners.org and ask those guys how they do it.

[Arlin Eastman]

Doug

I have never done any segmented work before and I am sure others will chime in also.

I grew up in Conifer Park and went to school in Evergreen and Boulder high school so a Hearty welcome buddy.

Arlin

[Doug_H]

Thanks, Arlin. Hope you are well.

Doug

[JTTHECLOCKMAN]

If you do not have room for a good quality mitersaw then maybe you need to move. They do not take up much room. You do not need a sliding miter. You will get better quality cuts and much more accurate.

[Dennis Puskar]

Drive the 20 min. and save yourself some aggravation.

[MichaelMouse]

Make a set of shooting boards to clean up your bandsaw cuts if you're a hand tool guy.

[Angus]

I can't imagine doing segmented work on a bandsaw or a miter box

[Doug_H]

Thanks to all

I appreciate your suggestions. Angus, I can't imagine it either.

My choices have boiled down to (1) drive the 20 minutes to visit all my stuff at my son's shop or (2) get a Byrne miniature table saw ($400-$500) Of course if I choose #2 I might also have to find a new place to sleep.

Doug

[Arlin Eastman]

Doug

I seen this the other day and thought of you.

http://www.ebay.com/itm/like/38100148170...noapp=true

or

http://www.micromark.com/MicroLux-Mini-M...ut-Off-Saw,9639.html?sc=WGB&utm_source=GoogleBase&utm_medium=feed&utm_campaign=GoogleBase&gclid=CjwKEAjw0pa5BRCLmoKIx_HTh1wSJABk5F_4kxRPtmw5LZkClOJ2kiwhMaHYAQdD5v3rMkFBZj69PBoCu8Dw_wcB

I also googled and came up with this


http://www.amazon.com/s/?ie=UTF8&key...sl_80oybogaz7_b


Arlin