Posts: 36,538
Threads: 3
Joined: Nov 2004
Location: RTP, NC
This morning I was using it, and it jammed. I found a bent brad stuck in it, so I took it out. I guess the brad hit something it was folded in half. After that it won't shoot 2" brads. It will shoot 3/4". I assume something's bent somewhere and it's not picking up the longer nails on the way down. It's a BN200C. Any suggestions? Visually it looks ok and it shoots the shorter nails.
Posts: 13,006
Threads: 0
Joined: Mar 2003
Check to see that the driver returns all the way up. Check for bent driver.
Al
I turn, therefore I am!
Posts: 36,538
Threads: 3
Joined: Nov 2004
Location: RTP, NC
Thanks. I will do that. Hopefully this is a quick fix. I'd rather put 18 guage brads into shoe mould than 16.....
Thinking about it, I think the driver bent/not retracting is the problem. I'll do some searching on the driver to be sure but recalling what I was seeing this morning I think that's the problem.
Posts: 12,046
Threads: 1,611
Joined: Jan 2001
Location: Kansas City, Kansas
Seems the piston seals might be leaking a skosh, not allowing the piston to fully retract.
I have a similar(if not the same) 18 guage nailer. And agree with the use there instead of 16 guage(which I also have).
I do have a Stanley/Bostich stapler that had that problem, was resealed under warranty. Has worked well for 15 years now.
Posts: 22,710
Threads: 0
Joined: Feb 2005
Location: Regina Saskatchewan Canada
What diameter are 18" brads? How much compressor do you need?
Blackhat
Bad experiences come from poor decisions. So do good stories.
