Woodnet Forums › › Active › Woodworking v
Making a Top for Router Table
Thread Modes
Making a Top for Router Table
pmaczik Offline
New User
Posts: 23
Threads: 0
Joined: Feb 2017
#13
02-20-2017, 10:30 PM
I've made a couple of them and bought a crapsmen, I am still not satisfied.  What are you using for table top.  I'm thinking to take my old craftsmen table saw from 1975 to a machine shop.  Have them to cut the whole for the router base to fit and make a stand or mount it on my Jet table saw.  I know at least it will always be very flat.
Find
Reply
museumguy Offline
Member
Posts: 2,078
Threads: 1
Joined: Feb 2009
Location: Mechanicsville, Md
#14
02-22-2017, 07:36 PM
I made mine out of 2 layers of 3/4" MDO, glued together. I did a dry glue up with clamps and cauls to make sure it was as flat as I could get. Came out wonderful.
I no longer build museums but don't want to change my name. My new job is a lot less stressful. Life is much better.

Garry
Find
Reply


Forum Jump:


Users browsing this thread: 5 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.