Posts: 17,368
Threads: 2
Joined: Sep 2002
Location: pburg, wv
ok, I'm going to have my AC (20+ years) replaced in the future. My house is basically a rectangle, the old section. It basically is split in four rooms.
Kitchen/dining area - Bedroom
----------------------------------- joist in basement
Living room (large return) - Bedroom
In the past my furnace / AC guy has said that when I replace it I should add returns to the two bedrooms. My question is the bedroom on the kitchen side will have to go under the joist. Will this be a problem with air flow?
mark
Ignorance is bliss -- I'm very, very happy
Posts: 22,710
Threads: 0
Joined: Feb 2005
Location: Regina Saskatchewan Canada
Maybe. Depending on the layout, I might joist line 2 adjacent joist bays and cut wall mounted returns into the common wall between the bedrooms. Common practise to use the joist bays as return air chases.
Blackhat
Bad experiences come from poor decisions. So do good stories.
Posts: 612
Threads: 1
Joined: Dec 2016
When I replaced my central a/c-heating system I added returns in the common areas of my home not in the bedrooms. Hallways and one in the den/living room area (above the fireplace). All 4 bedroom doors in my home are undercut so I get adequate return from them by having a return in the hallway central to all 4 bedrooms.
Nevermind..I just re-read you question and it sounds as if you ductwork runs in the basement. I would put returns in areas that aren't heavy traffic areas.
Posts: 5,733
Threads: 2
Joined: Dec 2004
Location: Fort Worth
02-23-2017, 01:55 PM
(This post was last modified: 02-23-2017, 01:56 PM by Robert Adams.)
Most houses just have have a single return under the unit if it's an upflow or attic mounted. More returns are always a good thing and will increase overall comfort in the house. Even if it's a little restricted any return is better than none at all.
Posts: 4,895
Threads: 0
Joined: May 2010
(02-23-2017, 01:55 PM)Robert Adams Wrote: Most houses just have have a single return under the unit if it's an upflow or attic mounted. More returns are always a good thing and will increase overall comfort in the house. Even if it's a little restricted any return is better than none at all.
Maybe that is standard for Texas but not for northern states
Posts: 2,033
Threads: 0
Joined: Jan 2003
My HVAC person told me that lack of returns was the most common reason for uneven heating/cooling. They pretty much wanted a return for every supply. We have a two story house that we did substantial work to the first floor, and had the hvac person in for a looksee because the house never heated or cooled evenly. We let him add the extra returns, and clean up some other items, and the house is pretty balanced now. They were not much of a fan of flex vent-said it reduced air flow a lot.
Posts: 17,368
Threads: 2
Joined: Sep 2002
Location: pburg, wv
(02-23-2017, 08:44 PM)toolmiser Wrote: My HVAC person told me that lack of returns was the most common reason for uneven heating/cooling. They pretty much wanted a return for every supply. We have a two story house that we did substantial work to the first floor, and had the hvac person in for a looksee because the house never heated or cooled evenly. ...
my house heats and cools pretty evenly, but the air return is pretty close to center of the house and I leave the two bedroom doors open at least some.
mark
Ignorance is bliss -- I'm very, very happy
Posts: 64,651
Threads: 3
Joined: Feb 2007
Location: Merryland
Can you cut any of the bottom of those open doors? Another 1" off the bottom of a door is about the same volume than a typical 10"x5"
wall return
Posts: 17,368
Threads: 2
Joined: Sep 2002
Location: pburg, wv
yep, that would work too, didn't think about that.
mark
Ignorance is bliss -- I'm very, very happy
Posts: 22,710
Threads: 0
Joined: Feb 2005
Location: Regina Saskatchewan Canada
Are you adding returns for more even airflow or to provide for the larger airflow requirements of a new higher efficiency furnace?
Blackhat
Bad experiences come from poor decisions. So do good stories.