Posts: 12,046
Threads: 1,611
Joined: Jan 2001
Location: Kansas City, Kansas
Can the panel wiring be extended? Yes.
SHOULD the panel wiring be extended? Whole 'nother situation. Connections should all be soldered and each solder joint insulated---shrink tubing is a good product. But, joints should be staggered(on each end) so no two joints are side by side. And the entire length of extended wiring protected in a casing and secured to a wall/machine side/etc. Why? Vibration will rub the insulation away and create a short circuit. The best result will be a burnt out control panel, the worst, a fire and probable home damage.
Posts: 18,495
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
Do you have a front-loading washer?
"Links to news stories don’t cut it." MsNomer 3/2/24
Posts: 13,412
Threads: 0
Joined: Jun 2004
Location: Texas
A 6 foot step ladder would be easier.
Posts: 349
Threads: 0
Joined: Sep 2006
(07-30-2017, 10:05 PM)Phil Thien Wrote: Do you have a front-loading washer?
Yes, I do. Are you asking just as an person-check,
or are you thinking of something else?
Posts: 349
Threads: 0
Joined: Sep 2006
Posts: 18,495
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
(07-31-2017, 10:11 AM)colibas Wrote: Yes, I do. Are you asking just as an person-check,
or are you thinking of something else?
Just in case you weren't considering leaving room to open a top-loader.
Just trying to be helpful.
"Links to news stories don’t cut it." MsNomer 3/2/24
Posts: 9,541
Threads: 0
Joined: Jan 2005
Location: Orlando FL
Just get a step stool and leave it as is.
Posts: 5,733
Threads: 2
Joined: Dec 2004
Location: Fort Worth
(07-31-2017, 10:11 AM)colibas Wrote: Yes, I do. Are you asking just as an person-check,
or are you thinking of something else?
So im assuming you have a front loader washer but not the matching front loader dryer but an older style machine.
It can be done but even me the type that modifys and customizes stuff wouldn't do it.
If your set isnthe same line then just get the stackink kit for it. Some are as little as $20. I stacked ours when I rebuilt the laundry room. Saves allot of space but if i had a very large laundry room i would build a 2' tall box with drawers to place the units on. The washer is just too low to the ground in stock form and those bases they make are only about half the height to get them usable. Unfortunately everything is designed for child height and those of us that are normal height end up with back problems because of it......
Posts: 5,653
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
I've been inside a dryer many times. They are || this close to a fire hazard as they sit. Messing with it seems like a bad idea.
Posts: 9,541
Threads: 0
Joined: Jan 2005
Location: Orlando FL
If the washer is front load and you will have to build something to hold the dryer over the washer, could you just put the washer over the dryer instead?
