Posts: 400
Threads: 0
Joined: Feb 2010
Location: Colorado
My friend has a nice French Oak dining table; very light, very very tight grain. The table was not finished! Apparently the designer thought it would be cool to develop a “patina” over time. But now it just looks like spills and stains.
I'd like to clean and finish it. But the spills look like oil, and I can’t tell how deep they’ve gone. How deep might they go? Can anyone tell? Is there a way to find out? What's the best way to bring it down to a clean look before finishing?
Thanks for any advice.
Posts: 741
Threads: 0
Joined: Mar 2006
I'd wash it all down with something like murphys oil soap first, and then after dry if you have oil stains work on them with acetone, brake cleaner, or numerous other remedies. They'll come out. Nothing gets oilier than old gunstocks with the finish worn away. And they come clean after a bit of effort.
Posts: 12,888
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
(01-24-2018, 03:39 AM)abecedarian Wrote: My friend has a nice French Oak dining table; very light, very very tight grain. The table was not finished! Apparently the designer thought it would be cool to develop a “patina” over time. But now it just looks like spills and stains.
I'd like to clean and finish it. But the spills look like oil, and I can’t tell how deep they’ve gone. How deep might they go? Can anyone tell? Is there a way to find out? What's the best way to bring it down to a clean look before finishing?
Thanks for any advice.
French oak most likely means white oak, and that's a good thing because the pores are plugged making it harder for liquids to penetrate very far, unlike with red oak. I, too, would start with MOS, but after that I would use mineral spirits or Naptha first to remove any remaining oil stains. You can always move on to the harsher solvents later, if those don't work.
John
Posts: 12,606
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
Sometimes stains that look "oily" will disappear with a coat of finish on them. To check, simply wipe the piece down with MS and see what it looks like. The caution would be that even if they "disappear" it might be something that finish won't adhere to, but one problem at a time.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.