|
trying to cut unknown angle accuratly
|
02-10-2018, 10:08 PM
I need to cut off both ends of two 4x4s at slightly over or under 90°
I've looked online and can't find any videos showing how to do. I have a chop saw, but do'nt know how to line up the blade to the line on the 4x4. The line is straight , butnot 90° tks, pa
Do you have a bevel Square? If so set it to the angle, then use it to set the blade.
If not, set the angle to what looks right, then make a test cut and adjust as needed. Several test cuts should get you there Edit to say welcome to the group
02-11-2018, 12:04 AM
Bevel square and a second piece of wood, milled to the same dimension. Use the bevel square to estimate the angle. Use the scrap piece to test this angle and cut the real piece when you get it right.
A carpenter's house is never done.
02-11-2018, 12:08 AM
(02-10-2018, 10:08 PM)paulmars Wrote: I need to cut off both ends of two 4x4s at slightly over or under 90° Chop saw or compound miter saw. Single or double angle(blade turned/tipped)? As stated, a bevel square is the best tool for the job. Another possibility(before I bought a bevel square) is to saw a kerf along the line with a hand saw and adjust the angle on the miter saw to fit the kerf.  
02-11-2018, 06:47 AM
(02-11-2018, 02:09 AM)ez-duzit Wrote: Cut it cleanly, to a scribed line, with a Japanese saw. +1. For a one-off it is faster to grab a hand tool than to fuss with the power tool
I tried not believing. That did not work, so now I just believe
02-11-2018, 06:56 AM
(This post was last modified: 02-11-2018, 06:59 AM by Snipe Hunter.)
I'm sure the guy with one post (quite possibly a spammer) who doesn't know how to cut an angle or what angle he has to cut owns a Japanese Saw.
02-11-2018, 01:30 PM
Paul,
Snipe Hunter may have a point. If you search for a Japanese pull saw, you may find them to be expensive. However there are some much cheaper clones. Search for "Shark pull saw" or "Irwin Pull Saw." They are both less than $20 US bucks. It is easy to cut to a line with this type of saw, and you will be surprised at how quickly you can get the job done. ![[Image: spin_prod_206242301?hei=624&wid=624&op_sharpen=1]](http://c.shld.net/rpx/i/s/i/spin/image/spin_prod_206242301?hei=624&wid=624&op_sharpen=1)
I tried not believing. That did not work, so now I just believe
|
|
|
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
