Start of something small

[bandit571]

The joys of being Retired.....I work only as much as i feel like, when I feel like it....


So....maybe a PIP, since I now have a coat of Poly Gloss on this little table?
  

   
Center view..not sure which way will be the "front"
 

   
Maybe this one?
 

   
Or this one?

Just one coat, so far

[bandit571]

One coat was just enough.  Table is done.  Other than rehabbing a couple chisels from recent rust hunts, not much going on.  Out of lumber, at the moment
 

Well, there are three 2 x 10 x 24" slabs sitting around, and a 1/2" x 2' x 2' maple plywood panel...not really enough to do much of anything with....yet.

Chisels being rehabbed?
 

   
Defiance by Stanley.  1-1/2" wide.   Needed a new handle. 
And last night's foray..
 

   
Needed a new edge done.  Old one was skewed, and at a 40+ angle for a bevel  
 

   
Crescent Tool Co. No. 175    1  1/4   Made in Jamestown N.Y., USA

More for Plumbers and Electricians..

   
I even repainted the red end, after removing the old Mushroomed part
 

   
Was part of a large tub of tools I picked for $5...Chisel is setting bevel down in that  photo, shadows showing up. 

Waiting on either a new stash of Lumber, or the next Rust Hunt trophy....

[Arlin Eastman]

What wood was it for the table top?  Also another project well done buddy.

[bandit571]

Table's top was just Pine from Menard's.....they had a pallet of what they called "Quality Boards" that had been cut to 4' lengths, I picked through and found an interesting one, that didn't have a bunch of knots.    Just a 1 x 10 x 48"....Made a pair of 1 x 10 x 24" pieces, and bookmatched them....

[Cian]

One coat was just enough.  Table is done.  Other than rehabbing a couple chisels from recent rust hunts, not much going on.  Out of lumber, at the moment...

Very nice. I do enjoy seeing your project posts.  Thanks for sharing.

[Skip J.]

Very nice. I do enjoy seeing your project posts.  Thanks for sharing.

Yes... excellent work.. Thanks!