Posts: 4,814
Threads: 1
Joined: Jan 2004
Location: Eugene, OR
Oops. I sharpen/hone my chisels freehand on water stones. I guess I have my tendencies -- I got one of them off square by a couple degrees, which is a lot. Any suggestions for how to bring it back? I do have a LV honing guide (rarely use it, but have it) if that would help.
Thanks in advance.
Best,
Aram, always learning
"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery
Web:
My woodworking photo site
Posts: 13,411
Threads: 4
Joined: Jun 2007
Location: New Jersey
(09-29-2018, 07:53 PM)Aram Wrote: Oops. I sharpen/hone my chisels freehand on water stones. I guess I have my tendencies -- I got one of them off square by a couple degrees, which is a lot. Any suggestions for how to bring it back? I do have a LV honing guide (rarely use it, but have it) if that would help.
Thanks in advance.
That would do it. Otherwise, you could buy a Tormek....
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis
Posts: 4,814
Threads: 1
Joined: Jan 2004
Location: Eugene, OR
(09-29-2018, 08:12 PM)Admiral Wrote: That would do it. Otherwise, you could buy a Tormek....
Sure. Do they make them hand-cranked?
Best,
Aram, always learning
"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery
Web:
My woodworking photo site
Posts: 7,008
Threads: 0
Joined: Aug 2004
Location: Perth, Australia
Use your honing guide on 120 grit sandpaper. Trizact is long lasting. Make the run about 1m (or as long as you can).
Regards from Perth
Derek
Posts: 106
Threads: 0
Joined: Jul 2016
Location: Poughkeepsie NY
Something to keep in mind, the LV honing guide is not going to magically square the edge. You will have to bias your sharping to the high side. Which comes to my suggestion, just bias your sharping each time you sharpen, eventually it will square up.
Posts: 4,814
Threads: 1
Joined: Jan 2004
Location: Eugene, OR
(09-29-2018, 10:30 PM)knockknock Wrote: Something to keep in mind, the LV honing guide is not going to magically square the edge. You will have to bias your sharping to the high side. Which comes to my suggestion, just bias your sharping each time you sharpen, eventually it will square up.
Thanks. Yeah, that's probably a good way to go.
Best,
Aram, always learning
"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery
Web:
My woodworking photo site
