Posts: 2,382
Threads: 0
Joined: Dec 2011
(10-10-2018, 11:02 PM)adamcherubini Wrote: One more than thing. I’ve glued up many edge joints prepared with my try plane. If the edge has a tiny hollow, that’s okay.
If you want to use your try plane for edge joints with PVA, that’s ok. But use a bunch of clamps and tighten them down pretty hard.
Again, I hope this helps
Not sure if you're talking about a spring joint by your term of a hollow edge. Or, you are referring to a hollow left by the camber blade across the edge. If the former, a spring joint reduces the no. of clamps needed for the edge glue-up.
Simon
Posts: 212
Threads: 0
Joined: Jan 2018
10-14-2018, 08:36 AM
(This post was last modified: 10-14-2018, 08:36 AM by CStan.)
Straight enough so that the lightest shaving you intend to take with the plane will still be 3/4's (++) the width of the iron on a board that's pretty flat. No bench plane should ever really be cutting with just its nose, a shaving only a half inch wide or less, unless you are just starting to surface a board and it's still very rough.
For a jointer plane iron, this implies a curvature that is almost imperceptible to the eye, you have to hold it up to a straight edge to "see" the curvature.
