Posts: 1
Threads: 0
Joined: Nov 2018
11-25-2018, 01:34 PM
(This post was last modified: 11-25-2018, 01:36 PM by Douglas B.)
I have a Delta 10" contractors saw. I am in search of the washer that screws onto the leading edge of my miter gauge to guide it in the "T" slot. I have done quite a bit of searching to no avail and I figured this would be a great place to start. The Flat head machine screw that attaches the "washer" to the miter gauge is what I believe to be a M6, 1.0 pitch screw do to the age of this saw, but may indeed be a finer thread machine screw, possibly a 1/4" fine thread SAE machine screw. If anybody could provide a source for this screw and guide, it would be greatly appreciated.
Thank you!
Doug B.
Posts: 84
Threads: 0
Joined: May 2011
Location: So Cal
(11-25-2018, 01:34 PM)Douglas B Wrote: I have a Delta 10" contractors saw. I am in search of the washer that screws onto the leading edge of my miter gauge to guide it in the "T" slot. I have done quite a bit of searching to no avail and I figured this would be a great place to start. The Flat head machine screw that attaches the "washer" to the miter gauge is what I believe to be a M6, 1.0 pitch screw do to the age of this saw, but may indeed be a finer thread machine screw, possibly a 1/4" fine thread SAE machine screw. If anybody could provide a source for this screw and guide, it would be greatly appreciated.
Thank you!
Doug B.
It 1/4 28 National Fine
Posts: 5,657
Threads: 0
Joined: May 2005
Location: Centre County Pennsylvania
I was looking at the washer on the miter gauge that came with my PM66. They tried to make it fit pretty well in the slot. But I think you don't really need that. But did you look on eraplacement parts or somewhere like that?
I could make you one, not sure when I would get around to it. I need to do some other work on the lathe, a washer is no big deal.
