Posts: 12,603
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
That looks like a 34-444 that I had, and it may have the motor that Delta rated at 1.5 HP for 120V, and 2 HP for 240V. In truth it's a 2 HP motor they derated at 120 to meet UL requirements. If that's the case you may still get what you want.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 191
Threads: 0
Joined: Dec 2011
01-12-2020, 09:49 PM
(This post was last modified: 01-12-2020, 09:50 PM by gtrboy77.)
It is indeed the 34-444. Here is a pic with the specs.
Posts: 191
Threads: 0
Joined: Dec 2011
01-12-2020, 09:52 PM
(This post was last modified: 01-12-2020, 09:54 PM by gtrboy77.)
Larger pic. I’ll try and get a pic of the motor plate.
Posts: 2,274
Threads: 90
Joined: Jun 2001
Looks exactly like my Craftsman 3 hp contractors saw.
John
Always use the right tool for the job.
We need to clean house.
Posts: 3,057
Threads: 0
Joined: Dec 2006
Location: Concord, NC
Two suggestions...one already has been made.
1. Dedicated dado blade setup.
2. Don't laugh but part it out on Ebay. I have done it and have gotten for more then I could have sold an intact saw for. Fence, rails, stand, crank handles, cast iron top, motor, etc....plus you have a mobile base.
"Life is too short for bad tools.".-- Pedder 7/22/11
Posts: 191
Threads: 0
Joined: Dec 2011
