Posts: 1,343
Threads: 0
Joined: Oct 2005
Location: Daytona Beach, Fl.
I have mixed up a solution of garnet shellac. I have checked the amounts of flakes to alcohol and know that that is correct. I have tried to filter it through paint filters and paper filters. Not much gets filtered through and that that does filter leaves a gritty surface after application. What type of filter material works best for you all out there? Any other suggestions? (I grind up the flakes in coffee grinder) Thanks.
Posts: 12,606
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
Puzzling. The shellac that is in the alcohol is completely dissolved. I always have some that doesn't dissolve when I mix it, but it comes out in the paint strainer. Are you sure the surface effect is from the shellac...maybe it's some raised grain? Put some of the shellac on a non wood surface (glass, laminate, whatever) and see if it feels rough.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 12,884
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
(02-21-2020, 06:28 AM)fredhargis Wrote: Puzzling. The shellac that is in the alcohol is completely dissolved. I always have some that doesn't dissolve when I mix it, but it comes out in the paint strainer. Are you sure the surface effect is from the shellac...maybe it's some raised grain? Put some of the shellac on a non wood surface (glass, laminate, whatever) and see if it feels rough.
That's the same as I was thinking - raised grain. It can be pretty rough after the first coat depending upon what wood it's applied to. I sand it back with 320 or 400 grit and then all is well.
John
Posts: 10,279
Threads: 1
Joined: Nov 2001
Location: Prince Frederick, MD
Are you talking about raised grain after the first application? If so, hit it lightly with 220 and apply again. This is typical.
Semper fi,
Brad
