03-17-2020, 09:36 AM
(03-17-2020, 07:09 AM)EricU Wrote: I have been following this thing since before they sold it. I would really like to have one, but just can't justify the expense. People are doing some really nice work with it.
Pretty much CNCs tend to have a minimum 4-figure entry point.
I had not been planning to buy at exactly the time I did but I was able to save about $100 on the shipping (they charge full rate and insure it, thing was packed very, very well). Still, it has blown a hole in my tool budget for at least the next 1-1/2 years.
But I don't regret spending the money. The little bit of CNC woodworking I was doing I can now do "in-house" and don't need to job out.
Don't sweat the petty things and don't pet the sweaty things. -- G. Carlin
