Posts: 4,814
Threads: 1
Joined: Jan 2004
Location: Eugene, OR
09-12-2020, 05:06 PM
(This post was last modified: 09-12-2020, 05:07 PM by Aram.)
Yorkcraft YC-8J again. I did something or other stupid a long time ago, and bent this pin. It catches the depth gauge (a sheet metal part not shown in the pic). It's not essential, but before I cut if off and grind it flat, is there any hope of replacing it? I assume it is press fit, so I am not seeing how.
![[Image: i-zDkCG8g-M.jpg]](https://photos.smugmug.com/photos/i-zDkCG8g/0/335580e4/M/i-zDkCG8g-M.jpg)
Thanks.
Best,
Aram, always learning
"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery
Web:
My woodworking photo site
Posts: 2,331
Threads: 0
Joined: Dec 2006
Location: virginia beach VA
Aram, not familiar with the jointer, but a few thoughts - can you apply some heat to it, without getting the table too hot, and then try to bend it back? Otherwise, you could always cut it off, then drill out a hole for a new pin
Posts: 4,814
Threads: 1
Joined: Jan 2004
Location: Eugene, OR
(09-12-2020, 08:56 PM)barryvabeach Wrote: Aram, not familiar with the jointer, but a few thoughts - can you apply some heat to it, without getting the table too hot, and then try to bend it back? Otherwise, you could always cut it off, then drill out a hole for a new pin
Oh, man. Duh. Yes, I could.
Thank you.
Best,
Aram, always learning
"Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away.” Antoine de Saint-Exupery
Web:
My woodworking photo site
Posts: 2,331
Threads: 0
Joined: Dec 2006
Location: virginia beach VA
Aram, glad to be of help. Hope it works out.
Posts: 14,850
Threads: 10
Joined: Jan 2010
Location: southeastern VA
Any chance that the pin is threaded?
Anyone have a parts list for that model?
"the most important safety feature on any tool is the one between your ears." - Ken Vick
A wish for you all: May you keep buying green bananas.
