Posts: 16,604
Threads: 0
Joined: Oct 2002
Location: Ra-cha-cha, NY
(01-16-2021, 08:50 PM)MauleSkinner Wrote: So is there a reliable way to determine that a compressor tank is reasonably safe?
You could proof test it. Fill it with water, then pump the pressure up to some proof pressure, like 250 psi. If it fails, there’s essentially zero stored energy in it, so it would just kind of leak or split a bit and spray a little water. But it won’t explode.
Tom
“This place smells like that odd combination of flop sweat, hopelessness, aaaand feet"
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
I had one about that size rust out 25-30 years ago.
I mounted everything on the side of a 100p LP tank. Wheels and all.
Used it for several years until I bought my first 60g upright.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 16,604
Threads: 0
Joined: Oct 2002
Location: Ra-cha-cha, NY
(01-17-2021, 12:15 PM)Stwood_ Wrote: I mounted everything on the side of a 100p LP tank. Wheels and all.
It was probably made to the
4BA240 spec, which has a 240 psi working pressure, with some design factor applied of course. Higher working pressure than most air receivers. There's also a spec for higher pressure (312 psi I think?), but most small cylinders are 240 psi. Presumably a bit heavier construction than an equivalent air tank, and little to no water in it during its lifetime.
Tom
“This place smells like that odd combination of flop sweat, hopelessness, aaaand feet"
Posts: 4,903
Threads: 0
Joined: May 2010
When I worked for a crop service we had a 25HP compressor mounted on a 350 gallon Propane tank
