Posts: 15,502
Threads: 0
Joined: Feb 2002
Location: Northeastern MA
You are frequently puzzled by things you tell us you fully understand. - Bob10 to EH 9/22/16
Too much has been made out of my mostly idle comments - Cletus 12/9/15
You sound like one of those survivalist, hoarder, tin foil hat, militia, clinger, wackjobs. - Fear Monger 1/30/13
Posts: 845
Threads: 0
Joined: Jun 2007
Rent the lift it is safer or hire it out. One of my brother in law's come off an 11 ft. roof painting. Neck, lower back and hips messed up. Now he is nearly blind going onto 9 yrs since it happened. Not worth being a cheapskate to save 3 nickels.
Posts: 12,610
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
04-02-2021, 02:38 PM
(This post was last modified: 04-02-2021, 02:41 PM by fredhargis.)
Many, many years ago I had that same problem and more-or-less did what you described in the opening post. Worked out well, except for the paint I dripped on the shingles. But I built a "triangle" and set my extension ladder on it. It may have been risky but it seemed plenty sturdy. I like the boom lift idea, but many of them around me have limited lateral reach, so if you choose that approach make sure it will get you to where you need to be.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 527
Threads: 0
Joined: Feb 2021
Location: Stevi, Montana
I have to say, I would hire a painter.
62 and bad back ain’t climbing tall ladders, not worth the risk....
Posts: 6,442
Threads: 0
Joined: Feb 2006
I hate ladders and being up high.. I'd pay somebody lol
Posts: 1,944
Threads: 0
Joined: Feb 2008
I would start by going into the attic and dropping something I could clip my lanyard to out of the gable vent. Because I have plenty of staging, I would set a pole on the front and back corners and a ladder section w/ hook on both sides of the ridge. I'd use a plank from the pumps to a rung until I could clear the ridge with a 28' pick. Crank the radio and paint to your hearts desire, shortening the lanyard as you ascend.
Sign at N.E. Vocational School Cabinetmaking Shop 1976, "Free knowledge given daily... Bring your own container"
Posts: 6,423
Threads: 0
Joined: Feb 2002
Location: Truro,N.S. Canada
(04-02-2021, 08:25 AM)brianwelch Wrote: I rented (actually had free use of) a boomlift to install siding on the high area of my house...not necessarily the cheapest route, but safe, and fun...
I considered pump jacks and plank, but the safety aspect had me a bit concerned...
I was fortunate in that way as well.I drove a tandem 30x8 foot tilt deck truck,my job was to move these pieces if equipment around.I was given free use of lifts,all I had to do was transport them,which was no problem,used my work truck.
Mel
ABC(Anything But Crapsman)club member
Posts: 4,672
Threads: 0
Joined: Jan 2008
i say what the consensus says- boom lift. articulating or boom? idk.
if you plan on jury rigging something, ill gladly hold your beer and watch.
Posts: 2,003
Threads: 1
Joined: Aug 2016
(04-03-2021, 11:37 AM)tomsteve Wrote: i say what the consensus says- boom lift. articulating or boom? idk.
if you plan on jury rigging something, ill gladly hold your beer and watch.
You can get to almost anything with the articulating type as the main boom will be out of the way when you go over something. Plan your work so you can do all the hard to get to areas using the lift. It will be a lot faster and safer. First thing I did with a new guy was to keep the basket low to the ground and extend out from the side all the way, see it is not flipping over. They would then be more comfortable at height. Just make sure the ground is stable. Roly
Posts: 18,627
Threads: 0
Joined: Jul 2006
Location: Milwaukee area
With the money you're saving by DIY, surely you can justify the cost of a lift.
![[Image: PivitTool-5_600x.jpg?v=1393007316]](https://cdn.shopify.com/s/files/1/0332/8901/products/PivitTool-5_600x.jpg?v=1393007316)
