Posts: 2,274
Threads: 90
Joined: Jun 2001
Ok. I just got a new SS that runs off 220v. I want my DC - 110v - to come on automatically when the SS comes on. I have one that turns on with 110 automatically.
So is there a remote that does this or do I have to jury rig something?
John
Always use the right tool for the job.
We need to clean house.
Posts: 30,415
Threads: 1
Joined: Dec 2002
Location: DuPage County, Illinois, USA
You can do what you described with an iVac setup.
https://www.ivacswitch.com/ivac-pro-auto-sensor/
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
Not the answer you want but for $25 or less I got a wireless outlet. I keep the controller on either the fence or the bandsaw.
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 3,057
Threads: 0
Joined: Dec 2006
Location: Concord, NC
That makes only the second 220v SS I have ever heard of...
I assume you mean a Shopsmith.
"Life is too short for bad tools.".-- Pedder 7/22/11
Posts: 2,274
Threads: 90
Joined: Jun 2001
(04-25-2021, 10:00 PM)Scott W Wrote: That makes only the second 220v SS I have ever heard of...
I assume you mean a Shopsmith.
Sawstop.
John
Always use the right tool for the job.
We need to clean house.
Posts: 8,381
Threads: 1
Joined: Mar 2000
When I first got my SawStop, I also got the iVac setup. I have two separate tool switches and one DC controller.
The setup worked OK, but wasn't flawless, though the DC being controlled was a 2HP Harbor Freight unit. While the controller is capable of working with that DC, sometimes it needs reset.
When I bought it, I intended to keep adding components as I added tools onto the DC system. After moving into the new shop, and really installing a centralized system, it hasn't worked out that way. When it came time to shell out dollars for added switches, I opted instead for an iVac RF remote to switch the DC on and off at my demand. That switch was only about $25.
I just wasn't willing to shell out dollars for fully automated DC on/off capability when I was going to have to manually switch blast gates anyway as I move between tools. I know I can automate those blast gates, but that's adding a level of complexity and cost that I'm not certain is wise for my shop situation.
I still have the gear, and I can reengage if I choose.
Posts: 2,274
Threads: 90
Joined: Jun 2001
I like that Ivac system. I have 3 tools I need to run and this would take care of it. The blast gates are a little expensive so Ill stick to the manual ones. All my other tools have shop vacs attached. The planner, drum sander and TS create too much dust for a vac.
So thanks guys. Sorry about the SS and not Sawstop at the beginning. I forget about the Shopsmith since I have never even seen one.
John
Always use the right tool for the job.
We need to clean house.
