Woodnet Forums › › Active › Woodworking Power Tools v
Setting up a miter cut on a RAS?
Thread Modes
Setting up a miter cut on a RAS?
cputnam Offline
multi-slacker
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
#12
09-02-2021, 09:30 PM
(08-31-2021, 09:58 AM)jteneyck Wrote: How would you hold the piece to make those end grain cuts?  Help me understand how a shooting board could be used for this.  

John
Looked at the drawing again - shot my virtual mouth off without engaging brain. No way to handle the stiped cut on a shooting board. Althoough a miter jack and chisel night well be of use.
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.