Help with M&T's?
#8
Need help from the experts here.

This is my first big M&T project, a big farmhouse trestle table. The joints will be pulled together with draw bores.

When dry fitting individual pieces, they all fit flush. When dry fitting the group, one doesn't sit right. The leg and base are 90*. All knee braces were built with jigs and stops, so they're interchangeable. I actually swapped these two and the gap was the same in the same spot.

I'm thinking that maybe this mortice there isn't giving me the correct clearance? It's an angle mortice, so maybe I didn't dig it out correctly.

Before I go in and mess things up more, can I get some advice or ideas?


Attached Files Image(s)
   
   
   
Semper fi,
Brad

Reply
#9
If there is a gap on both braces and you are sure the angles are correct then the mortises in the post and/or horizontal piece need to be lengthened, or the tenons trimmed a little.  The other possibility that comes to mind is that the braces are a little two long.

John
Reply
#10
Take a rasp, round over the edges of the tenon.
If it doesn’t fix it, pencil marks it to see where the mortise needs a but more excavation.
A little gap in the bottom won’t hurt anything anyway.
Gary

Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Reply
#11
Brad, your dry fit is much closer than when I built that style table for my DNL.  I tend to agree with John's last comment: braces may be too long.
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply
#12
Thanks, folks. After posting I realized I need to ensure that there is a gap in the bottom to allow for the draw bore to work.

The braces are actually about 1/8" shorter than the plans, but the mortices are laid based on the pieces, not the drawings.
Semper fi,
Brad

Reply
#13
I trimmed then as suggested and everything fits tightly.

Thanks!


Attached Files Image(s)
   
   
Semper fi,
Brad

Reply
#14
(09-04-2021, 04:52 PM)®smpr_fi_mac® Wrote: I trimmed then as suggested and everything fits tightly.

Thanks!

Glad you got it sorted out.  Looks really good now.  

John
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.