Woodnet Forums › › Active › Woodworking v
Router Bit
Thread Modes
Router Bit
MsNomer Offline
Wood Recycler
Posts: 14,947
Threads: 0
Joined: May 2005
Location: Oklahoma
#4
09-18-2021, 01:07 PM
Is there a router bit with the opposite profile of a dovetail bit?  IOW, large diameter at the base tapering to smaller at the tip?  It would also need to be small enough to be used safely in a Osch Colt.

I have an edge I need to bevel on an existing piece.
Carolyn

Trip Blog for Twelve Countries:   [url=http://www.woodworkingtraveler.wordpress.com[/url]

"It's good to know, but it's better to understand."  Auze Jackson
Website Find
Reply
fredhargis Offline
Member
Posts: 12,604
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
#5
09-18-2021, 02:15 PM (This post was last modified: 09-18-2021, 02:15 PM by fredhargis.)
Do you mean a bevel/chamfer bit? Would the bearing be a problem?
   
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Find
Reply
MsNomer Offline
Wood Recycler
Posts: 14,947
Threads: 0
Joined: May 2005
Location: Oklahoma
#6
09-18-2021, 03:44 PM
Well, duh. Brain fart. That will work just fine. Thanks.
Carolyn

Trip Blog for Twelve Countries:   [url=http://www.woodworkingtraveler.wordpress.com[/url]

"It's good to know, but it's better to understand."  Auze Jackson
Website Find
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.