<p>Checked one off the bucket list today; finally published a book!</p><p>“Beginner’s Guide to CNC Machining in Wood”, from Fox Chapel Publishing, went on sale this morning.</p><p><br></p><p>https://www.woodcademy.com/book-store-1/2021/6/12/beginners-guide-to-cnc-machining-in-wood<br></p><p><br></p><p><br></p>
(09-22-2021, 03:53 PM)EightFingers Wrote: Too bad that didn’t come out ten years ago, I would have ordered it.
You have to learn a lot quick to get going in CNC.
I agree there are lots of pieces that have to work in order to be successful at CNC. Perhaps this is why it was 6 months before I was reasonably confident in what I was doing with my CNC.
I am not 'quick'
Patience and persistence and lots of mistakes on the way was / is my CNC journey.
<p>Bill,</p><p><br></p><p>Back when I trained operators in pro shops, I always told them that it would be 6 months before they were skilled and confident enough to be able to program, set up and run a job faster than it used to get done with traditional machines. </p><p><br></p><p>So you were right there!</p><p><br></p>
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
