Posts: 1,131
Threads: 0
Joined: Jun 2004
(12-16-2021, 09:02 PM)Timberwolf Wrote: ......................
A piece of cotton web belting glued to a board makes a very good strop when charged with honing compound. The rough, slightly corrugated surface really holds the charge a long time. Never tried nylon belting but I'll bet it would work as well...
Now THAT is a good idea!
It's all wood.
Posts: 4,011
Threads: 0
Joined: Nov 2010
About the use of the blue jeans...really quite safe...as long as you remember to PULL the chisel with the edge pointing away from you..just like on a normal strop..
3 pulls back on the bevel, 1 pull on the back, 2 pulls on the bevel, one final pull on the back...check for any burrs. Pulls can either be up the pants leg, or across....I'm sitting down anyway....so I guess that could count as set-up time for the "strop"?
ps: I usually only go to 2500 grit, then either the old leather work belt strop, or the Unicorn Wheel....then back to work. Don't really want to use the 6" grinder. I usually use the 6" disc sander to produce a flat bevel..then oil stones (2) then the 1000, 1500, 2000, and then the 2500 grits....A small blob of 3in1 oil to help out...so, where do I set the paper at...why right on top of the last oilstone...floating the paper on a thin layer of oil... Stone is, after all, flat enough to work, makes a nice flat surface to sit the wet-or-dry paper on...the oil tends to keep the paper in place..no need to clamp it, Jed. Hmmm. ....have yet to try the 3000 grit.....YMMV ( I have work to do..)
Show me a picture, I'll build a project from that
