Posts: 1,808
Threads: 0
Joined: Nov 2006
Location: SF Bay Area
We have a roof intersection where the eaves are at different levels. Is there a standard way to box this in to prevent rats from getting back in under the eaves of the higher roof?
Posts: 70
Threads: 0
Joined: Oct 2021
A bit late but I would have framed it in prior to roofing than used a roof to wall type flashing and stop the gutter so lined up with gutter below. At this point I'd just fab up some 24 gauge sht metal seal it up real well with caulk & it will be rat proof.
Posts: 64,651
Threads: 3
Joined: Feb 2007
Location: Merryland
I also would have framed it in with a fascia board and flashed accordingly and then installed the roofing
Posts: 38,525
Threads: 0
Joined: Feb 2002
Location: East Texas
I have that problem on our barn.
rats like to hang out there, I've shot dozen's of them hanging out there over the years. often I'll shoot one and any others will run to the other side, where I shoot another. One night I killed 16 going back and forth before I ran out of pellets, by the time I got back the rest had left.
would I had known, I would have sealed mine up.
Reality is that which, when you stop believing in it, doesn't go away. - Philip K. Dick
Mark
Posts: 12,197
Threads: 2
Joined: Nov 1999
Location: Nebraska City
It's hard to imagine a profesional framer or a roofer leaving that alone.
Posts: 24,039
Threads: 0
Joined: Jan 2004
The problem with just boxing it in, without killing the animal is they see it as their home. They’re going to do their best to get back in. Kill the ones living there before completing the work.
Matt
If trees could scream, would we be so cavalier about cutting them down? We might, if they screamed all the time, for no good reason.
-Jack Handy
Posts: 1,808
Threads: 0
Joined: Nov 2006
Location: SF Bay Area
(07-18-2022, 10:50 AM)Snipe Hunter Wrote: I also would have framed it in with a fascia board and flashed accordingly and then installed the roofing
Yes, that was the plan.
How crazy is it to remove section of new roofing, membrane, and sheathing, fix and reinstall? Is that something that can be localized or does it blow up?
The issue isn't just a convenient den in this location, but that there are gaps that allow access into the attic.
We haven't seen rats recently, but this was an access point for them years ago. At the time, we had shake roof, and we blocked off access into the overlapped area with a combination of hardware cloth and concrete in the tight areas where the hardware cloth couldn't be adequately secured.
If trying to use flashing now, how would it be secured to the lower roof? (on top of roof, or tucked under anything?)
Matt
