How do I square one end of this blank?

[Stwood_]

The Bosch won't cut all the way through, short by about an inch. 

I was able to cut and rotate and get it close enough, leaving just a small corner uncut.  I hit it with my router plane to clean up.

Yes, has to be rotated. I never had a problem doing that.

The only circle saw next size up that will make one cut through a 6x6 is a 14"-16" RAS. Those can be picked up dirt cheap, discarded from the older lumber yards. 3PH.....

Add another tool to your arsenal.

[®smpr_fi_mac®]

Yes, has to be rotated. I never had a problem doing that.

The only circle saw next size up that will make one cut through a 6x6 is a 14"-16" RAS. Those can be picked up dirt cheap, discarded from the older lumber yards. 3PH.....

Add another tool to your arsenal.

When I build a bigger shop a 14-16" RAS will be added, but I got rid of my Dewalt 1030 last year due to space limitations...and because this SCMS can cut deeper.

[Stwood_]

Yes, 14-16's are valuable when working with big stock