Posts: 706
Threads: 0
Joined: Dec 2006
... this can't be that hard, and yet.
My wife would like a large pegboard for hanging hats, coats, and things. "No problem", thinks I, "I can do a 20mm layout using my workbench tooling".
And then I completely fail to find 20mm wooden dowels. Anywhere.
So - help? Does anyone have a source? I'm looking for maybe 4" long (20mm by 4", that's a good combination) but I can also cut down anything longer. The closest I've found is a really sketchy dowel jig from eBay/AliExpress that would let me cut down a 1" dowel but - see "sketchy".
I don't have a lathe but I do have a drill, so I suppose I could sand something down...
Computer geek and amateur woodworker.
Posts: 38
Threads: 0
Joined: Aug 2013
Location: Northern Virginia
20 mm aluminum rod can be found, at least on ebay. You may be able to find a supplier for wooden dowels in the UK or Europe.
Posts: 12,605
Threads: 0
Joined: Aug 2003
Location: Wapakoneta, OH
There's some listed on Etsy, I also found some listed at Walmaert (!),but they were only 50mm long.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Posts: 10,774
Threads: 0
Joined: Jul 2005
Location: Front seat on the Struggle Bus
Posts: 24,145
Threads: 2
Joined: Sep 2003
Location: Missouri
Ck here. I've bought from here for years. Good people.
Dowels up to 48" long last I looked.
https://www.midwestdowel.com//
If it isn't listed, ask them.
Steve
Mo.
I miss the days of using my dinghy with a girlfriend too. Zack Butler-4/18/24
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020
Posts: 22,222
Threads: 0
Joined: Nov 2002
(12-18-2023, 05:35 PM)EdL Wrote: Just use 3/4
Ed
20 / 25.4 = 0.7874"
Therefore, 3/4" dowels will be a bit small. That's probably what is driving OP crazy.
Rip to width. Plane to thickness. Cut to length. Join.
Posts: 596
Threads: 0
Joined: Mar 2007
Location: NW of Fort Worth, TX
An idea suggested on another site was to drill a 20mm hole in a piece of steel to create a dowel plate and hammer 7/8" dowels through the hole to make the 20mm dowel. Actually the suggestion was to go to a machine shop and have them drill the hole.
Posts: 175
Threads: 0
Joined: Dec 2016
One approach would be to get a router quarter round bit with 10mm radius. The with a 20 mm square length of material mill the dowel from the center section leaving flat square ends to register against the router table's fence (assuming of course you do have a router table).
Posts: 605
Threads: 0
Joined: Aug 2007
Location: ex TX, now central Maine
Possibly the best way if you don't have the proper power tools is with a
Hollow Auger in a bit brace. You just set the diameter you need and crank away, piece of cake...
A spoke pointer can help to get it started.
Cliff
Cliff
ex-TX, now Maine!
