Finishing one off "the shelf"
#3
Finishing a black walnut natural edge bowl. This bowl was roughed out years ago and sat on a shelf because the mortise warped too badly for the chuck to grab it to final turn. After gluing on a waste block and finish turning, it was sanded to 600 grit, Myland's sanding sealer applied and finished with acrylic enamel.
Reply
#4
Did a lot of those type bowls, in fact near the end those were the only ones I turned because they sold so well. I didn’t like sanding the “wings”, lot of finesse to get it just right.

I would put a bow tie patch over the cracks.
VH07V  
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.