Posts: 102
Threads: 0
Joined: Jul 2021
A squirrel runs up the wood column of the front porch and gnawed a two-inch hole in the crown molding. Whatever repair is made will have to be sculpted to match the contours of the molding.
First I’ll wad up some chicken wire to stuff in the hole. My question is: What kind of waterproof, moldable material would be good to use. I had thought of Wood Putty, but the label says not waterproof.
Posts: 12,889
Threads: 0
Joined: Jan 2010
Location: Lewiston, NY
(10-01-2024, 08:11 AM)Petertaylor Wrote: A squirrel runs up the wood column of the front porch and gnawed a two-inch hole in the crown molding. Whatever repair is made will have to be sculpted to match the contours of the molding.
First I’ll wad up some chicken wire to stuff in the hole. My question is: What kind of waterproof, moldable material would be good to use. I had thought of Wood Putty, but the label says not waterproof.
Bondo would be my choice.
Might be good to make sure the culprit hasn't taken up residence before closing the hole. They can do a lot of damage trying to get out.
John
Posts: 102
Threads: 0
Joined: Jul 2021
Thank you, John. I hadn’t heard of that, but looked it up and the wood filler product is what I’ll use.
Posts: 1,939
Threads: 0
Joined: Feb 2008
10-02-2024, 11:07 PM
You can use the same bondo to make a matching profile sanding block. Wax or oil a good section of the profile you want to duplicate, gob on some bondo, and press a small block of (clean, bare) wood against it. When it's fully set, pop it off, and trim off the excess. You can use that "sanding block" to mark the profile on your choice of steel for a molding scraper. This works well when the Bondo is at that "hardness"(?) when you would typically use a cheese grater.
If you feel like getting a little creative, you can use waxed or oiled wood to help get the profile close to the finished product. Think; dowels to recreate flutes. Or even just tacking on a block to recreate an inside or outside corner. And just in case you thought you were really creative; I haven't had much luck using Bondo to mold Bondo.
Remember. Wax sticks to everything, nothing sticks to wax.
Sign at N.E. Vocational School Cabinetmaking Shop 1976, "Free knowledge given daily... Bring your own container"
Posts: 24,057
Threads: 0
Joined: Jan 2004
You’ll need to kill the squirrel before sealing the hole. Until then, they’re motivated to chew a new hole.
Matt
If trees could scream, would we be so cavalier about cutting them down? We might, if they screamed all the time, for no good reason.
-Jack Handy
Posts: 64,695
Threads: 3
Joined: Feb 2007
Location: Merryland
I had a squirrel eating wires under the hood of my van. Replaced a wiring harness 3 times. I finally made a box trap with 1/2 mesh hardware cloth. I released the squirrel about 2 miles from the house and it had nearly knawed through the wire by the time I released it... maybe 15/20 minutes at the most. My experience is that they don't give up or forget easily. It will just make a new hole.
