Richardson Brothers 14" backsaw
#21
Eric,

This was the action shot - Dominic with one of his small card scrapers!



Dom - very nice rehab. Handle looks stunning.

Steve
Reply
#22
Dom, you've definitely raised the bar on restorations. Is that a 4" or 5" saw plate? The proportions look nice.
True power makes no noise - Albert Schweitzer.       It's obvious he was referring to hand tools
Reply
#23
Dominic. I blogged about this 2 days ago. It happes often when I build a saw. It usually means a bit of adjustment to mortice or groove. Or starting all over if it is too bad.

Blog adres is below.
Reply
#24
If this was a newly made handle I'd say you nailed it. But this is an old handle that I just refinished.

HOWEVER, Stewie, you and Issac bring up a good point. There has got to be some wood movement or interference involved here. Maybe even a scrap of debris in the slot? I didn't really check it close enough. As soon as I get a chance I'm removing the saw plate and checking. I'll report back.
See ya around,
Dominic
------------------------------
Don't you love it when you ask someone what time it is and to prove how smart they are, they tell you how to build a watch?
Reply
#25
Nice job Dominic!

I was just thinking about this saw last weekend. I saw a Richardson Bros handle and that made me think of your saw.
Reply
#26
Dom,

Sorry, I was on my break.

I agree with both Isaac and Stewie. One more thing to check.... remove the handle and check to make sure the blade is in line with the back as the blade extends down below the back. To check this, clamp the back in a drill press vise or some other way to hold the back square to a flat surface, with the blade pointing upward. Then check both sides of the blade with a square to see if the blade leans to one side. Sometimes you will even discover a twist in the blade.

If the blade is not in line with the back, when you tighten the cheeks, they will try to line the blade up with the back. Try using only the screws through the cheeks and not the screw through the back. If the back and the blade are out of alignment, that upper screw is working against the lower screws.
Catchalater,
Marv


I did then what I knew how to do. Now that I know better, I do better.”
― Maya Angelou

I'm working toward my PHD.  (Projects Half Done)
Reply
#27
Dom ......... Great job on the resurrection, that turned out really nice. I actually like the dark handle with all the steel, nice contrast.

Thanks for sharing.

Steve
Reply
#28
Mmmmm shiny. Nice work Dom and a lovely saw.
-- Andy -- Old Chinese proverb say: If you think something can't be done, don't interrupt man who is doing it.
Reply
#29
Bump for the saw restorers.
...Naval Aviators, that had balz made of brass and the size of bowling balls, getting shot off the deck at night, in heavy seas, hoping that when they leave the deck that the ship is pointed towards the sky and not the water.

AD1 T. O. Cronkhite
Reply
#30
Bump for retention...
...Naval Aviators, that had balz made of brass and the size of bowling balls, getting shot off the deck at night, in heavy seas, hoping that when they leave the deck that the ship is pointed towards the sky and not the water.

AD1 T. O. Cronkhite
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.