Really? Outfeed table height on 19-38 SuperMax
#9
I'm in the process of building another workbench for my shop and I'd like to use it as an outfeed table for a SuperMax 19-38 drum sander(future purchase).

I called them and asked for the height of the conveyor belt/outfeed table from the floor with casters and the lady said, "It's 47" to the top of the dust cover." I said, "No I need to know the height of the conveyor belt/ outfeed table."....now on hold. "The height to the bottom of the conveyor belt is 33"." I said, "no I need to know the height to the top of the conveyor belt. The wood comes out on top." She said, "It's just a few inches higher." I said, "What are a few inches."....on hold again. "The top of the conveyor belt is 36" from the floor."

Not that I don't trust her expertise, but could anybody confirm her measuring prowess.

Thanks,
Gary

Living under the radar, heading for "off the grid."

Reply
#10
My 16/32 is at 34 1/4, my Uni is at 34 7/8 for what it's worth.
Jim

THANK OUR MILITARY THAT WE ARE FREE

If I accepted, that'd mean I didn't have any integrity..
AND then I'd meet your expectations as a politician..
Fred Kingston...052708
Reply
#11
Are you related to the gal at SuperMax?
Gary

Living under the radar, heading for "off the grid."

Reply
#12
my sawstop is at 36.5" HTH







you can always add height by adding a spacer to the future purchase. Or it might change dimensions.. build your table at a comfortable height and then adjust future machines to fall within that height.
My Day Job
well, bye.
Reply
#13
glzahn said:


Are you related to the gal at SuperMax?




They let you out of the basement and yer on a roll!
Jim

THANK OUR MILITARY THAT WE ARE FREE

If I accepted, that'd mean I didn't have any integrity..
AND then I'd meet your expectations as a politician..
Fred Kingston...052708
Reply
#14
My 19-38 outfeed table height is at 35 1/2 inches using the 3" Woodcraft locking swivel casters (#148595). It appears to have about a half inch plus or minus of adjustment with the casters.
Reply
#15
AdamR said:


My 19-38 outfeed table height is at 35 1/2 inches using the 3" Woodcraft locking swivel casters (#148595). It appears to have about a half inch plus or minus of adjustment with the casters.




You must have read the question!
See ya later,
Bill
Reply
#16
it is surprising how that happens at least on occasion



Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.