Garage Door Opener malfuction
#7
  Re: (...)
Pulled into the drive and hit the remote in my truck and the door goes up. Pull into garage and hit remote to close the door, it goes part way down and then back up. Remote, wired button at kitchen door and keypad does nothing. I have power to unit, and can hear a relay clicking, but nothing happens. Manual trouble shooting is worthless. Craftsman 1/2 hp Model #139.53975SRT1. Any suggestions? Thanks in advance.

Jim
Reply
#8
  Re: Garage Door Opener malfuction by NWOhioJim (Pulled into the driv...)
The eyes are misaligned that go across the door opening.
Reply
#9
  Re: Garage Door Opener malfuction by NWOhioJim (Pulled into the driv...)
Safety sensor-I just had the same problem.
the LED was on as normal, replaced sensors and all is well again.
Reply
#10
  Re: Re: Garage Door Opener malfuction by rlnguy (Safety sensor-I just...)
Oh and I put ours on the ceiling taped together so I don't have to mess with it. However when you go to sell make sure you put them back to functional again.
Reply
#11
  Re: Garage Door Opener malfuction by NWOhioJim (Pulled into the driv...)
Sometimes I trace my opener problems back to a stuck button on the remote.

My boss is a Jewish carpenter. Our DADDY owns the business.
Trying to understand some people is like trying to pick up the clean end of a turd.
Reply
#12
  Re: Re: Garage Door Opener malfuction by Robert Adams (The eyes are misalig...)
That's it! Didn't think they had moved, but moved enough to loose contact. Check everything out and all is now well, and thanks for the replies.

Jim
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.