Posts: 2,722
Threads: 0
Joined: Dec 2005
There never seems to be enough area in the shop to put stuff on. Not necessarily a space to work, but a space for stuff to sit when its not being worked on or not yet put where it belongs. My jointer collects stuff, as does my table saw, my router table, etc. I finally decided to install more table surface area, and it ended up looking a lot like a workbench. Woodcraft had 60" x 27" x 1-1/2" birch bench tops on sale (around $120), and the legs were glue-ups of some cherry that was about 75% sap wood. A 2x4 cleat attached to the wall, and your done. Wish I had done this long ago.
Posts: 229
Threads: 0
Joined: Jun 2005
Great looking auxiliary bench. If things go anywhere near the way they go around my place, it won't be long before it's full, and you need an auxiliary bench to catch the overflow.
I will point out that there is room for a shelf underneath.
Flat space is always at a premium.
Robin of Kingston
Posts: 2,722
Threads: 0
Joined: Dec 2005
Actually it was full by about 5:00 this afternoon!
Posts: 1,030
Threads: 3
Joined: Jun 2011
Location: N. Cincy inside the loop
Time to add a shelf or two underneath.
Posts: 6,678
Threads: 1
Joined: Jan 2003
Location: Southern California
I'm sure there is a Murphy's law that states something to the effect of: No flat surface goes unpiled for as long as needed.
Thanks, Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
-- Soren Kierkegaard
Posts: 4,263
Threads: 0
Joined: Feb 2001
I believe Murphy's law states that any flat surface will accumulate stuff and fill up until there is no more room.
I will bet that the top is about half full now.
Tom
Posts: 730
Threads: 0
Joined: Apr 2010
Location: Olathe, Kansas
Nice! That reminds me of when I could see my shop floor.
Mike
Funny on occasion, embarrassing on average.
