A few of my boxes (pics)
#11
Between big projects I like to make boxes. They are not the works of art that I have seen others produce but I find it relaxing and the tight tolerances keep my woodworking skills sharp:

" />

" />

" /> " />

" />



" />
I had a good day. I used every tool I own!
Reply
#12
Very well done, beautiful work.

Mel
ABC(Anything But Crapsman)club member
Reply
#13
I make boxes for the same reasons you do Jim. Practicing tight tolerances can only be good.

I presume those intricate designs are shop sawn veneers because solid wood could blow those mitered frames, right? Either way the craftsmanship looks top notch from here.

Keep on making them and don't forget to tweak proportions regularly.
Lumber Logs, domestic hardwoods at wholesale prices: http://www.woodfinder.com/listings/012869.php

Lumber Logs' blog: Follow the adventure
Reply
#14
Solid, not veneer Tom! So far I haven't had any problems, maybe because all the wood in them has been dried in the same place for years. Your point is well taken however. I learned it the hard way with one of my first pieces--a coffee table with fixed (so I thought) breadboard ends. It may also help that the pieces are so small. Most of the wood in them was given to me by a former turner which switched to photography. Some really exotic pieces in there: zebra wood, canary wood, thorn knob, and so on.

Papa Jim
I had a good day. I used every tool I own!
Reply
#15
very nice
Reply
#16
Very nice!
Thanks,  Curt
-----------------
"Life can only be understood backwards; but it must be lived forwards."
      -- Soren Kierkegaard
Reply
#17
Very nice Jim, what method do you use to cut the d/t sockets
Reply
#18
I built a 45/45/90 jig out of 3/4" stock about as wide as the boxes are high. I just use quick grips to clamp the box to the jig, adjust the fence on my router table and run them through a 1/2" d/t bit. Then I use the same set up to create the d/t spline. I have also just used the t/s to make straight splines. Finger joints also make an interesting corner treatment. I haven't tried it yet but I also built a jig that will allow me to run the boxes through the t/s at an angle. I will use a thin kerf blade and hopefully the splines will look like the box corners are stitched together. I also want to try "cats eyes" splines. All part of the fun!
I had a good day. I used every tool I own!
Reply
#19
thanks Jim
mark
Reply
#20
I like the wood grain swirl top one.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.