Posts: 21,440
Threads: 2
Joined: Mar 2009
Location: IA
I have checked a few places for a 1" x 8tpi headstock to 1 1/4" x 8tpi male thread so I can use my 1 1/4 chucks on a 1 x 8 midi lathe.
Help with a link is great
As of this time I am now teaching vets again. If you have any lumber scraps we can use them to glue up to make some bowl from a board which we have not done yet.. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 1,640
Threads: 0
Joined: Feb 2000
Here you go Arlin
linky for adapterSelect size needed
George
Life is tough, tougher if you're stupid
John Wayne
Posts: 10,758
Threads: 1
Joined: Jan 2006
Location: Orlando, Florida
Still Learning,
Allan Hill
Posts: 21,440
Threads: 2
Joined: Mar 2009
Location: IA
Thanks guys. I went there a few hours ago and did not notice the drop down box and it did not show sizes and thought it was a close out.
Arlin
As of this time I am now teaching vets again. If you have any lumber scraps we can use them to glue up to make some bowl from a board which we have not done yet.. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 15,010
Threads: 10
Joined: Jan 2010
Location: southeastern VA
George and Alan already beat me to the link for the one from Craft Supply. I suspect that that one is solid.
If you need one that works with a vacuum chuck or works as an MT2 extension, then try
Best Wood Tools. Best Wood Tools is a husband and wife company that supplies first rate products. They occasionally get hard to reach when they get overloaded or when one of them gets sick. I have always had good dealings with them, but they have upset some other folks here. Their booth at the AAW symposium was always so busy when I was in the vendors room that I did not get a chance to chat with them this time.
"the most important safety feature on any tool is the one between your ears." - Ken Vick
A wish for you all: May you keep buying green bananas.
