Woodnet Forums › › Active › Finishing v
Anybody use an ultrasonic cleaner on spray guns?
Thread Modes
Anybody use an ultrasonic cleaner on spray guns?
Wild Turkey Offline
Honored Veteran and Retired Cold Warrior
Posts: 24,327
Threads: 0
Joined: Feb 2002
Location: Elizabethtown, KY
#4
09-12-2016, 11:20 AM
I'm in the middle of a complete tear down/clean all the nooks and crannies on my good HVLP sprayer.  Yep, lots of nooks and crannies full of paint
Rolleyes

I'd probably use my sprayer more if it didn't take so long to clean it after use.

I've see ultrasonic units clean some tough stuff -- I'm wondering if they could do spray guns?
Confused
"Truth is a highway leading to freedom"  --Kris Kristofferson

Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)
Find
Reply
Snipe Hunter Offline
MasterCarpainter
Posts: 63,451
Threads: 3
Joined: Feb 2007
Location: Merryland
#5
09-12-2016, 05:49 PM
There should only be paint between the cup and the tip. That's only about a one inch long area, if that. Is something wrong with the gun? Blown seals?
Neil Summers Home Inspections




" What would Fred do?"

... CLETUS











Website Find
Reply
Wild Turkey Offline
Honored Veteran and Retired Cold Warrior
Posts: 24,327
Threads: 0
Joined: Feb 2002
Location: Elizabethtown, KY
#6
09-13-2016, 10:08 AM
Good point -- Now that I've got it good and clean I'll try spraying something and see if the finish goes places it shouldn't.
"Truth is a highway leading to freedom"  --Kris Kristofferson

Wild Turkey
We may see the writing on the wall, but all we do is criticize the handwriting.
(joined 10/1999)
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.