37-315 jonter head indexing tool
#10
  
Anyone have one of these that either doesn't need it or can provide some measurements, so I can attempt making one.

A picture of it is on page 4 of the Manual

Bob
Reply
#11
  Re: 37-315 jonter head indexing tool by bobs64ford352 (Anyone have one of t...)
Consider this a bump. I'm going to have to see if my jointer has the provision for that. I may have to make one myself. It's been a long time since I read the manual.
Reply
#12
  Re: 37-315 jonter head indexing tool by bobs64ford352 (Anyone have one of t...)
Here's what I made.


Attached Files Image(s)
   
Reply
#13
  Re: 37-315 jonter head indexing tool by bobs64ford352 (Anyone have one of t...)
here is what I made 




here is how to use it
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply
#14
  Re: 37-315 jonter head indexing tool by bobs64ford352 (Anyone have one of t...)
(10-03-2016, 09:50 PM)JGrout Wrote: here is what I made 

Which is how I do it.
Reply
#15
  Re: RE: 37-315 jonter head indexing tool by Axl ([quote='JGrout' pid=...)
(10-03-2016, 09:55 PM)Axl Wrote: Which is how I do it.

Cool Cool Cool
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply
#16
  Re: 37-315 jonter head indexing tool by bobs64ford352 (Anyone have one of t...)
When I had knives on my jointer I used the wooden stick method as well...works great.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Reply
#17
  Re: RE: 37-315 jonter head indexing tool by toolmiser (Consider this a bump...)
Thank you, that is perfect. 

I have also used the wooden stick method before and will start with that, it might not be worth making the tool where I'm pretty close to pulling the trigger on a byrd head anyways.

Bob
Reply
#18
  Re: 37-315 jonter head indexing tool by bobs64ford352 (Anyone have one of t...)
That indexing bracket was made to accommodate the knife grinder accessory.  It works if and only if the holes in the end of the cutterhead are where they should be.  Not all 37-315 cutter heads were drilled as precisely as they should have been so check that.  I've seen a few that were not.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)