Posts: 2,488
Threads: 0
Joined: Aug 2004
I have a Steel City Model # 55210 16-32. Long story short, I can't locate the abrasive template. I attempted to make one (95" Long) but not so good results. I don't want to cut again until I know what direction to go in. Any help would be appreciated.
Jim
Posts: 29,152
Threads: 1
Joined: Aug 2002
Wrap a piece of string around the drum and mark the intersection where they meet.
Take it to the paper or just measure the length of the sting and mark the paper on the opposite side of the corner you want to begin on.. mark it with a straightedge across the paper or just cut using the straightedge for the first cut.
Wrap the paper on until you get to the other end mark it there and use the string again to layout the final cut
All you have to remember is the direction for the second cut and cut diagonally as before
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future John F. Kennedy
Posts: 2,488
Threads: 0
Joined: Aug 2004
Do I lock one end of the string in the retainer clip?
Jim
Posts: 29,152
Threads: 1
Joined: Aug 2002
Well you should the first time at least so the lead wrap is long enough
if that proves to be the case add the same amount to the other end
If it is too long then you only lose a few inches if that when you re cut the end
Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future John F. Kennedy
