02-03-2017, 02:56 PM
I'm not having any luck finding 3/8-24 x 3/4" thumb screws (spade head). Finding them with 16 tpi is no problem, but I can't find them with 24 tpi. Anyone know of a source?
|
Thumb Screw Source
|
02-03-2017, 03:20 PM
(02-03-2017, 03:12 PM)sweensdv2 Wrote: Did you try www.grainger.com I looked on their website and also checked McMaster-Carr and Fastenal. Can't find any with fine threads. 
02-03-2017, 04:27 PM
Credo Elvem ipsum etiam vivere
Non impediti ratione cogitationis 
02-03-2017, 04:32 PM
(02-03-2017, 02:56 PM)Lynden Wrote: I'm not having any luck finding 3/8-24 x 3/4" thumb screws (spade head). Finding them with 16 tpi is no problem, but I can't find them with 24 tpi. Anyone know of a source? 3/8 24 is an odd duck, you may not be able to be picky about head shape?? These will be round flat heads, or T shape
Worst thing they can do is cook ya and eat ya
 GW (02-03-2017, 04:32 PM)Steve N Wrote: 3/8-24 is an odd duck, you may not be able to be picky about head shape?? This is for the end of the feed shaft on my old Delta No. 645 drill press, so I was trying to find a bolt which looks original. I made one out of a knurled washer and a carriage bolt which looks good, so I'll use it until I find a thumb screw. Thanks everyone for your replies. For anyone who owns an old Delta drill press (Homecraft 11-120, No. 645, DP-220, etc.), don't lose the thumb screw. You might not be able to find another one. |
|
|
Users browsing this thread: 1 Guest(s)