03-08-2017, 08:23 PM
Shop made Goose neck chisel?
Found an old Drum Brake adjuster....and a screwdriver handle...hmmmm..spend a while at the grinder, and beltsander.....
Refine the one end into a chisel edge....curved, of course. Regrind the other curved end into a tang for the handle to fit onto.
Had to "adjust" the handle a bit, for a better fit....results?
No... I did NOT burn the steel. It is a shadow. Rotate..
On the outside of the curve is the beveled edge( a Bevel Down tool
)
So, now I can reach into a mortise, and clean the bottom out of all the chips down there. I had the narrow this down to 1/4" so I could use it in more than one size mortise.
Not too hateful? Price was right...
Found an old Drum Brake adjuster....and a screwdriver handle...hmmmm..spend a while at the grinder, and beltsander.....
Refine the one end into a chisel edge....curved, of course. Regrind the other curved end into a tang for the handle to fit onto.
Had to "adjust" the handle a bit, for a better fit....results?
No... I did NOT burn the steel. It is a shadow. Rotate..
On the outside of the curve is the beveled edge( a Bevel Down tool
)
So, now I can reach into a mortise, and clean the bottom out of all the chips down there. I had the narrow this down to 1/4" so I could use it in more than one size mortise.
Not too hateful? Price was right...
Show me a picture, I'll build a project from that