03-11-2017, 10:26 PM
Hello All ... for those of you that don't wander over to OWWM, I have made, in the past, some repro badges for older woodworking machines ..... I was asked if I could make a decal for a Delta Grinder, and did so for a machinist that made the plates ... then was asked to make another, but that guy decided to try it on his own.......so I went ahead and made a couple, with the plates that I received from a machinist in Michigan......now to my post........I have two available, shown in the pics......These are water slide decals placed on aluminum discs.....They have been sealed with clear satin acrylic, so they are ready to install.... I need to say, for those who are not familiar, that the decal itself is very thin plastic, and can be somewhat fragile. You need to exercise care when installing etc. Keep in mind, these are very good, but they are not a silk screened decal. $40 ea., and that includes shipping.......Paypal is best if possible ....... PM if interested.
![[Image: miK64Ej.jpg?1]](http://i.imgur.com/miK64Ej.jpg?1)