Rockwell 10 blade raises too high
#13
(09-13-2017, 10:34 PM)daddo Wrote: Fit a block of wood to stop the arbor at the right height then epoxy it to the underside.

This, my friend, has been my back up plan all along. I just preferred a more "accurate" fix... but the wood will work. 

Thanks all
"Life is too short for bad tools.".-- Pedder 7/22/11
Reply
#14
(09-14-2017, 05:42 AM)Scott W Wrote: This, my friend, has been my back up plan all along. I just preferred a more "accurate" fix... but the wood will work. 

Thanks all

 Use accurate wood.  
Wink


If the cast top is thick enough, you can drill and tap a hole to accept a 1/4" screw through the top and above the arbor. It would have to be counter sunk.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.