Incra Miter Gauge on Hammer K3??
#7
Hello,
Wondering if anyone has tried to modify an Incra miter gauge to fit in the slot on a Hammer K3... and if so, how?
Thanks!
Reply
#8
(10-17-2017, 11:46 PM)Israel Wrote: Hello,
Wondering if anyone has tried to modify an Incra miter gauge to fit in the slot on a Hammer K3... and if so, how?
Thanks!

I haven't done it but IIRC Incra can/will make custom miter bars for different tablesaws that then will fit onto their standard miter gauge heads. You might want to shoot them an email with the Hammer's miter slot dimensions and see what they say.
Raised
2023-2024 NFL Pick 'em
Group ID#: 34296
Group Password IBTP
Reply
#9
I doubt it would be too hard 

Take the head off the miter bar on the incra then using the existing parts from the CC on the slider figure out how to fit them together 

the only thing you really need is the locking nut that goes in the slider and the detent point. If it was me I would mock up a "BAR" out of wood to figure out the important locations then either use aluminum bar to fabricate one or take it to a machinist to make one from steel 


Joe
Let us not seek the Republican Answer , or the Democratic answer. Let us not seek to fix the blame for the past. Let us accept our own responsibility for the future  John F. Kennedy 



Reply
#10
(10-18-2017, 08:15 AM)Lumber Yard® Wrote: I haven't done it but IIRC Incra can/will make custom miter bars for different tablesaws that then will fit onto their standard miter gauge heads. You might want to shoot them an email with the Hammer's miter slot dimensions and see what they say.
Raised

there is this:

http://benchmark.20m.com/tools/HammerB3/...stall.html
Reply
#11
I think that this is what you are looking for: http://benchmark.20m.com/tools/HammerB3/...stall.html

Regards from Perth

Derek
Articles on furniture building, shop made tools and tool reviews at www.inthewoodshop.com
Reply
#12
(10-21-2017, 03:54 AM)Derek Cohen Wrote: I think that this is what you are looking for:  http://benchmark.20m.com/tools/HammerB3/...stall.html

Regards from Perth

Derek

Thanks for forwarding the link--very helpful!!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.