small radius templates
#11
What do you use to draw curves with a radius in the 0.5" to 2" range? I am needing to layout several 1" radius curves. I don't have a wing cutter to make little disks on the drill press.
Reply
#12
Fender washers.
Reply
#13
Washers, loose change, bottle caps, rolls of tape, just about anything that is round, handy and the right size.
If you are going down a river at 2 mph and your canoe loses a wheel, how much pancake mix would you need to shingle your roof?

Reply
#14
A set of hole saws usually goes from .75" to 2.125".
"I tried being reasonable..........I didn't like it." Clint Eastwood
Reply
#15
I have a handy plastic circle template that has a range of circles at about 1/8" diameter increments. They are available at hobby/craft stores or anywhere they sell drafting supplies or you can order from Amazon.

Circle Template

Such templates are also available with different shapes such as ellipses, rectangles, triangles, etc.

These flexible curves are also handy:

Flexible Curve

A set of french curves are also handy:

French Curves
Reply
#16
Thanks for the help. I will take a look at the hobby store. Fender washers is also a great idea but I keep using them for other purposes. Maybe I need to buy an assortment and keep a set in the super secret hiding place only to be used for templates or just getting lost. 
Smile
Reply
#17
(11-28-2017, 07:38 AM)Bope Wrote: What do you use to draw curves with a radius in the 0.5" to 2" range? I am needing to layout several 1" radius curves. I don't have a wing cutter to make little disks on the drill press.

compass.  I have one for small circles and a beam compass for circles up to 12" radius or so.  Anything bigger I just drill two holes in a piece of scrap.

https://www.dickblick.com/products/staed...gJ5gfD_BwE
WoodNET... the new safespace
Reply
#18
Dividers / compass.
Reply
#19
The bay has used radius gage sets for not much.  I have a set of Lufkins that I've had for many years.  Don't use them a lot but they can be handy.

Lonnie
Reply
#20
Rockler sells corner radius templates? The reviews are good.

http://www.rockler.com/quick-corners-set...&sid=V9146

Or make a set....

http://www.woodsmithtips.com/2012/09/13/...out-tools/
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.