Posts: 21,254
Threads: 2
Joined: Mar 2009
Location: IA
It is an off set Taper Metal Turning Attachment in 3MT Shank for Off-setting Lathe's Tailstock.
https://www.amazon.com/dp/B06X6CY9VV/ref...rd_w=Dywrp
If you do a lot of off set work this may help. I am thinking of getting it in the future.
What do you think?
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
Posts: 114,743
Threads: 0
Joined: Jun 2002
Location: Sparkling Clearwater, Fl. Tampa Bay Area
(03-26-2018, 08:03 PM)Arlin Eastman Wrote: It is an off set Taper Metal Turning Attachment in 3MT Shank for Off-setting Lathe's Tailstock.
https://www.amazon.com/dp/B06X6CY9VV/ref...rd_w=Dywrp
If you do a lot of off set work this may help. I am thinking of getting it in the future.
What do you think?
,,,,,,,,
Looks like it has a #3 Morse taper, Arlin...What size does your lathe have? My wood lathes have a #2 in both headstock and tailstock...My metal lathes have #3 Morse in the headstock..
Often Tested. Always Faithful. Brothers Forever
Jack Edgar, Sgt. U.S. Marines, Korea, America's Forgotten War
Get off my lawn !
Posts: 5,411
Threads: 0
Joined: Jun 2001
Location: Troy IL
03-27-2018, 08:56 AM
(This post was last modified: 03-27-2018, 09:01 AM by Woodshop.)
(03-26-2018, 08:03 PM)Arlin Eastman Wrote: It is an off set Taper Metal Turning Attachment in 3MT Shank for Off-setting Lathe's Tailstock.
https://www.amazon.com/dp/B06X6CY9VV/ref...rd_w=Dywrp
If you do a lot of off set work this may help. I am thinking of getting it in the future.
What do you think?
It only helps if you have a carriage to run your tool bits. Then you get a long taper.
You can do the same with a wood lathe by putting a stop on the turning tool and angle the tool rest . much easier
Life is what you make of it, change your thinking, change your life!
Don's woodshop
Posts: 21,254
Threads: 2
Joined: Mar 2009
Location: IA
(03-27-2018, 08:56 AM)Woodshop Wrote: It only helps if you have a carriage to run your tool bits. Then you get a long taper.
You can do the same with a wood lathe by putting a stop on the turning tool and angle the tool rest . much easier
Don
I am not following your direction of thought. Can you explain it in an easier way for me.
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification. Thank You Everyone.
It is always the right time, to do the right thing.
