Pre Finished help
#6
I am working with pre-finished plywood for the first time. A friend of mine had some left over from a project he finished. The plywood has some light scratches on it. They don’t go through to the plywood itself.

What can I do? I’m trying to find out what kind of finish is on it to begin with but my friend isn’t sure himself. Should I scuff the whole thing and re-apply a spray coat?

Thanks
Angelo
"In order to achieve greatness we must risk everything"--Steve Jobs
Reply
#7
(05-03-2018, 07:10 AM)angelosart Wrote: I am working with pre-finished plywood for the first time. A friend of mine had some left over from a project he finished. The plywood has some light scratches on it. They don’t go through to the plywood itself.

What can I do?  I’m trying to find out what kind of finish is on it to begin with but my friend isn’t sure himself. Should I scuff the whole thing and re-apply a spray coat?

Thanks
Angelo

Maybe (this is a guess only) treat it like French polish and rub in some shellac.  The shellac should adhere to the finish and fill the scratches.  Try a sample first.  I doubt that the shellac will soften a modern finish.  But try a section near the edge first.
No animals were injured or killed in the production of this post.
Reply
#8
That finish is a commercial UV cured coating, you'd have a hard time repairing it in any way. I have been able to paint some by scuffing it, a coat of shellac, then the paint...and it seemed to adhere fairly well. Columbia Forest Products describes their finish as an "acrylate" formula (some form of acrylic) and go on to suggest that the finish can be cleaned with acetone. So it's tough, solvent resistant stuff. Bear in mind that may vary some by manufacturer.
I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
Reply
#9
That's one reason I don't use pre-finished plywood.  I think your best option is to try to buff out the scratches using auto body products.  I've used a product called Triple Cut that works really well for light scratches.  It will leave a gloss sheen.  If your plywood is something other than gloss you'll need a different product.  If so, look at Maguire's or one of the other polish companies' products.   

John
Reply
#10
I just rub on some lacquer or poly.  Which ever I have handy.  It will not fill the scratch but hides it pretty well.  You can repair deep scratches by building up the scratch and sanding it smooth then respray the whole surface - tedious but does work.  I would not put a finish over it w/o lightly sanding.

If you want you can sand the finish and then respray with lacquer or use poly.  I use pre-finish a lot.
John

Always use the right tool for the job.

We need to clean house.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.