Posts: 3,718
Threads: 0
Joined: Nov 2010
$30 + sales tax.....
Cleaned a little of the brown stuff off..
Sole was free of any cracks or pits..
And a surprise..
3 Patent dates.....
But..there is a couple strangers involved..
Like a SW iron?
To be continued......
Show me a picture, I'll build a project from that
Posts: 3,718
Threads: 0
Joined: Nov 2010
Ok...tore it down to just ..parts
First surprise was the front knob was a Millers Falls one....happen to have a spare Stanley one...
This was a bit better.....type 11 / 12 base....no pitting, no cracks...
Small parts seemed to match up with the base sating. That chipbreaker even has the underside a blue colour...Iron may be almost the only "new" parts
Well other than the front handle..and this lever cap....
Frog seemed to be correct.
To be continued....
Show me a picture, I'll build a project from that
Posts: 3,718
Threads: 0
Joined: Nov 2010
Went ahead and sharpened the iron.....got the chipbreaker to sit up close to the edge. Iron's back needed flattened. Went to assemble everything back together..
For some reason...mouth opening didn't ......was too tight...I even backed the frog back a bit....nada. Turned out, the iron was a bit thicker than the plane needed....I also backed the chipbreaker back from the edge a bit. Filed the front of the opening a bit. Picture above is the result....it will cut, no chatter.
Gives me two smoothers, with the grooved bottoms..
The Stanley #4c was a Made in England
So...may just keep this No. 3 c around?
In case the rest of the Type 11 parts show up...
Show me a picture, I'll build a project from that
Posts: 428
Threads: 0
Joined: Dec 2002
$30 +! Wow I'm used to seeing prices from you in the $2 to $3 range! :-) I love type 11 / 12 plane's!
Posts: 1,150
Threads: 0
Joined: Nov 2006
Location: Texas - Gods Country
Love #3's. Also love corrugated bottoms. They tune up so well as they are so easy to "flatten".
Nice find, and thanks for sharing.
Posts: 3,718
Threads: 0
Joined: Nov 2010
BTW....the plane hanging around in the background? A Sargent made Dunlap #3 sized, smooth soled plane..
Happen to have a few planes in the #3 size range
Show me a picture, I'll build a project from that
Posts: 10,118
Threads: 0
Joined: Sep 2006
Location: South Alabama
Sweet! I found one similar a year or so ago. I cleaned it up intending to sell it, but then after trying it out, I just couldn't put it down. It's become a regular user in my shop.
Great buy, and a nice clean-up job to boot. Well done!
Steve S.
------------------------------------------------------
Tradition cannot be inherited, and if you want it you must obtain it by great labour.
- T. S. Eliot
Tutorials and Build-Alongs at
The Literary Workshop
Posts: 5,009
Threads: 0
Joined: Jan 2014
Location: Santa Maria, Ca
Good find. Well done.
Mark Singleton
Bene vivendo est optimum vindictae
The Laws of Physics do not care about your Politics - Me
Posts: 3,718
Threads: 0
Joined: Nov 2010
Small box project...been using this "new" plane for a lot of the work..
Flattening glued up panels.....with ease
To making raised panels...
Even jointed an edge or two, after I had to trim the panels to size. Then did the raising
Been doing decent enough work in Maple.
Show me a picture, I'll build a project from that
