Advice needed on legs--Updated with pics--
#25
Ya done good!

Doug
Reply
#26
Good looking table.

How did you get that bevel on the top piece? Especially on the end grain sides.
Reply
#27
(12-31-2018, 08:18 AM)camp10 Wrote: Good looking table.  

How did you get that bevel on the top piece?  Especially on the end grain sides.

Thanks everyone. The bevels were cut on the table saw with the blade angled about 20*. I made an auxillary fence about 18" high out of MDF and bolted it to the face of my Incra TSLS. I added feather boards both infeed and outfeed. I was careful to feed at an even rate but cutting the bevels was quick and easy.

g
I've only had one...in dog beers.

"You can see the stars and still not see the light"
The Eagles: Already Gone
Reply
#28
That turned out nice! I like it a lot better than your earlier pic. Your wife has a good eye.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.