Mystery Jig... I think -->Can you tell me what it is??
#27
(01-01-2019, 08:49 PM)Phil Thien Wrote: Clamp the material to be cut to the jig at any angle/position desired using the provided t-slots and hold-downs, run the jig against the fence and cut your workpiece.

I am not seeing any hold-down clamps that came with the assembly jig or in the OP's photos that can hold down, say, a 1/4" thick 3" wide, 20" long strip, or a 2" x 3" x 25" long leg blank.

Simon
Reply
#28
(01-01-2019, 03:18 PM)jlanciani Wrote: It’s part of the Garrett-Wade “universal assembly jig”, see here; http://www.thewoodshop.20m.com/garrettwade1.htm

+1

Could also be used to throw at those pesky squirrels out back of the shop......
Winkgrin
Steve

Missouri






 
The Revos apparently are designed to clamp railroad ties and pull together horrifically prepared joints
WaterlooMark 02/9/2020








Reply
#29
(01-01-2019, 09:15 PM)Handplanesandmore Wrote: I am not seeing any hold-down clamps that came with the assembly jig or in the OP's photos that can hold down, say, a 1/4" thick 3" wide, 20" long strip, or a 2" x 3" x 25" long leg blank.

Simon

I can see a tapering jig pretty easy there.  Add the upper long flat UHMW to the bottom at a different width and buy a few clamps and run it thru the saw.  Not to hard to imagine unless a person is like me and it just gets hard to focus sometimes or widen out my thought pattern.
Yes
As of this time I am not teaching vets to turn. Also please do not send any items to me without prior notification.  Thank You Everyone.

It is always the right time, to do the right thing.
Reply
#30
In other words, one can TURN it into a tapering jig, but can't use it as a tapering jig as we woodworkers know it. That I can agree to.

Simon
Reply
#31
(01-01-2019, 03:18 PM)jlanciani Wrote: It’s part of the Garrett-Wade “universal assembly jig”, see here; http://www.thewoodshop.20m.com/garrettwade1.htm

AWESOME!!!!

Nice find. I spent hours on the web trying to solve this mystery.

THANKS!!!!

-jj
Reply
#32
post it in the shop and sell forum if you decide not to keep it, I might want to turn it into a tapering jig
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.